TH120 ARGB Sync
Thermaltake TH120 is a RGB colors all-in-one liquid cooler with singular 120mm powerful high static pressure fan and a smart fan controller. The 120mm highly-efficient radiator to control any escalating CPU temperatures. The TH120 ARGB Sync is designed to exceed user expectations.
Tt LCS Certified is a Thermaltake exclusive certification applied only to products that pass the design and hardcore enthusiast standards. The Tt LCS certification is to ensure you will get the best performance from the best features and fitment.
The 120mm RGB radiator fan with high-static pressure design, producing impressive cooling performance.
Special designed 120mm large surface radiator increases the cooling surface and exceptional heat dissipation.
The high performance copper base plate accelerates the heat conductivity. Additionally, the pre-refilled coolant reduces any stress from liquid replenishment hassle.
Featuring superb cooling performance, the TH120 ARGB Sync provides an easy installation system and a totally maintenance-free operation, requiring only the minimum amount of space in the chassis.
Featuring superb cooling performance, the TH240 ARGB Sync provides an easy installation system and a totally maintenance-free operation, requiring only the minimum amount of space in the chassis.
Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks
1. To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
2. Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
3. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
4. Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop setup
1. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
2. Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
3. DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
4. Fill the reservoir to the top as it will prevent air from going into the pump
5. If necessary tilt the system slightly from side to side to bleed the air out of the loop.
6. Place some paper towels under fittings and joining points to test for leaks.
7. Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop
8. Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components
|Pump|| Rated Voltage: 12 V / 5V
Rated Current : 0.37 A / 0.12A
Motor Speed : 3300 R.P.M
|Water Block||Material: Copper|
|Fan|| Dimension: 120 x 120 x 25 mm
Speed: 1500 RPM
Noise Level: 28.2 dB-A
Rated Voltage: 12 V & 5 V
Max. Air Flow: 59.28 CFM
Max. Pressure: 1.31 mm-H2O
Connector: 2510–4 Pin , 5 V ARGB header–3 Pin
|Tube|| Length: 400 mm
|Radiator||Dimension: 153x 120 x 27 mm|
|COMPATIBILITY|| Intel LGA 1156/1155/1151/1150
- File Name
- Release Date